X40 macro recording instructions

There are two ways to create macros for the X40:

Option 1: On the keyboard [no Software Driver needed]

Option 2: Through the Software Driver application

---

Option 1:

1. Press Fn+F12 [the MR key] to enter Macro Recording Mode [F12 indicator LED blinks].
2. Press an M-key [e.g., M1] to begin recording [F12 indicator LED turns off].
3. Type the keys [actions] to be recorded.
4. Press Fn+F12 [the MR key] again [F12 indicator LED turns on] to end recording. The driver will show the macro. Your macro has been set successfully.

---

Option 2:

• Open the Driver Software.

• Open the Macro Settings tab.

• Select one of the drop-down menus for each of the M keys.

• Mouse over Assign a Macro and click on Macro Manager.

• (red) Click New, name your macro, and press Enter. (green) Click the Start Record button. (orange) Enter the keys for your macro. (green) Click the Stop Record button. (purple) Click OK to exit the Macro Manager window.

• (red) Click an M button to assign your macro to. (green) Click Apply, then click OK to save settings.

Success! Your macro has been set.