M50 profile cycling instructions

The M50 mouse allows you to configure and customize 5 profile settings. While you must use the M50 Driver Software to set up your profiles, you do not need the software to actually swap between profiles. These profiles are saved onto the memory of the mouse, allowing you to take the mouse anywhere and have your profile settings ready to go.

To cycle between profiles, please follow these instructions:

• Start the M50 driver software.
• Choose one of the buttons as your Profile Cycle key. As shown in the screen capture below, we've used the DPI Up button and made it function as the Profile Cycle for Profile 1. Click Apply, and in each profile, make the same button your Profile Cycle function.

• After applying the Profile Cycle setting, you can set the MAIN, BUTTON and LIGHT SETTINGS in each Profile page, then apply the settings. However, you should always keep at least one button as the Profile Cycle button.
• Once this has been completed for each of the five profiles, click Apply to save your settings and click OK. You may now cycle between profiles by clicking the button you've assigned as the Profile Cycle function.